Removing A 3.5 Inch Hard Drive - HP ProDesk 405 G4 Small Form Factor Maintenance And Service Manual

6. Connect the power cable and data cable to the rear of the drive.
7. Connect the opposite end of the data cable to one of the light-blue SATA connectors on the system board
labeled SATA1 or SATA2.
NOTE:
connectors.
8. Reassemble the computer.

Removing a 3.5 inch hard drive

1. Prepare the computer for disassembly
2. Remove the access panel
3. Disconnect the power cable (1) and data cable (2) from the rear of the hard drive.
34 Chapter 4 Removal and replacement procedures
See the System board connections on page 23
(Access panel on page
for an illustration of the system board drive
(Preparation for disassembly on page
18).
17).