HP ProDesk 600 Maintenance And Service Manual page 199

Control panel message
163-Time & Date Not Set
163-Time & Date Not Set
164-MemorySize Error
164-MemorySize Error
201-Memory Error
213-Incompatible Memory Module in
Memory Socket(s) X, X, ...
214-DIMM Configuration Warning
219-ECC Memory Module Detected ECC
Modules not supported on this Platform
Description
Invalid time or date in configuration memory.
RTC (real-time clock) battery may need to
be replaced.
CMOS jumper may not be properly installed. Check for proper placement of the CMOS
Memory amount has changed since the last
boot (memory added or removed).
Memory configuration incorrect.
RAM failure.
A memory module in memory socket
identified in the error message is missing
critical SPD information, or is incompatible
with the chipset.
Populated DIMM Configuration is not
optimized.
Recently added memory module(s) support
ECC memory error correction.
Recommended action
Reset the date and time under Control
Panel (Computer Setup can also be used). If
the problem persists, replace the RTC
battery. See the Removal and Replacement
section for instructions on installing a new
battery, or contact an authorized dealer or
reseller for RTC battery replacement.
jumper if applicable.
Press the F1 key to save the memory
changes.
1.
Run Computer Setup or Windows
utilities.
2. Make sure the memory module(s) are
installed properly.
3. If third-party memory has been added,
test using HP-only memory.
4.
Verify proper memory module type.
1.
Ensure memory modules are correctly
installed.
2. Verify proper memory module type.
3. Remove and replace the identified
faulty memory module(s).
4.
If the error persists after replacing
memory modules, replace the system
board.
1.
Verify proper memory module type.
2. Try another memory socket.
3.
Replace DIMM with a module
conforming to the SPD standard.
Rearrange the DIMMs so that each channel
has the same amount of memory.
1. If additional memory was recently
added, remove it to see if the problem
remains.
2. Check product documentation for
memory support information.
POST numeric codes and text messages
189