Removing A 3.5-Inch Hard Drive - HP EliteDesk 880 G4 TWR Maintenance And Service Manual

Removing a 3.5-inch hard drive

NOTE: Before you remove the old hard drive, be sure to back up the data from the old hard drive so that you
can transfer the data to the new hard drive.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
4. Disconnect the power cable (1) and data cable (2) from the rear of the hard drive.
5. Rotate the drive cage up (see
6. Remove the drive by pulling the release tab away from the drive (1) and sliding the drive out of the bay
(2).
(Preparation for disassembly on page
(Access panel on page
(Front bezel on page 20).
Drive cage on page
19)
28)
18)
Drives 37