DGS-6604
ip igmp version
ip igmp version {1|2|3}
Syntax Description
1
2
3
Default
Command Mode
Usage Guideline
Example
Switch# configure terminal
Switch(config)# interface vlan1000
Switch(config-if)# ip igmp version 3
Switch(config-if)# end
CLI Reference Guide
Use this command to change the IGMP version on the specified interface.
Configure the Switch to run IGMP version 1.
Configure the Switch to run IGMP version 2.
Configure the Switch to run IGMP version 3.
3
VLAN interface configuration
If the IGMP interface version is configured to a lower version, then the higher
version IGMP Report/Leave messages are ignored.
This version will apply to both IGMP and IGMP snooping operation.
This example shows how to configure IGMP version. It configures the IGMP
version to 3.
Verify the settings by entering the show ip igmp interface command.
ip igmp version
280