Setting The Powered Zone 2 - Onkyo DTR-40.2 Instruction Manual

Zone 2 Video Output
The AV receiver features a composite video output for con-
nection to a TV in Zone 2, so you can enjoy both audio and
video in that zone.
Hookup
• Use a composite video cable to connect the AV receiver's
ZONE 2 OUT V jack to a composite video input on your
Zone 2 TV.
Main room
AV receiver
Zone 2
Note
• The ZONE 2 OUT V jack outputs video from components con-
nected to composite video inputs.
TV
TV

Setting the Powered Zone 2

If you've connected your Zone 2 speakers to the AV
receiver, as explained in "Connecting Your Zone 2 Speak-
ers Directly to the AV receiver"
"Powered Zone 2" setting to "Act" (Activated).
1
Press Receiver followed by Setup.
The main menu appears onscreen.
Tip
• If the main menu doesn't appear, make sure the appropri-
ate external input is selected on your TV.
2
Use / to select "Speaker Setup", and then press
Enter.
The "Speaker Setup" menu appears.
2. Speaker Setup
1. Speaker Settings
2. Speaker Configuration
3. Speaker Distance
4. Level Calibration
5. Equalizer Settings
6. THX Audio Setup
3
Use / to select "Speaker Settings", and then
press Enter.
The "Speaker Settings" menu appears.
2–1. Speaker Settings
Speaker Impedance
Speakers Type(Front)
Powered Zone2
4
Use / to select "Powered Zone 2", and use
to select:

Not Act:
Use FRONT WIDE/ZONE 2 L/R terminals to
connect front wide speakers. (Powered Zone 2
disabled.)

Act:
Use FRONT WIDE/ZONE 2 L/R terminals to
connect Zone 2 speakers. (Powered Zone 2
enabled.)
5
Press Setup.
The setup menu closes.
Note
• Powered Zone 2 cannot be used if "Speakers Type(Front)" is
set to "Bi-AMP" (➔ 50).
• This procedure can also be performed on the AV receiver by
using Setup, arrows, and Enter.
(➔ 76), you must set the
6ohms
Normal
Not Act
/
En
77