Powered Zone 2 Setting; Using Zone 2 - Onkyo TX-SR703 Instruction Manual

TX-SR803_En.book Page 83 Friday, August 26, 2005 9:26 AM
Zone 2 —Continued

Powered Zone 2 Setting

If you've connected your Zone 2 speakers to this AV
receiver, as explained in "Using Only Speakers in
Zone 2" on page 82, you must set the "Powered Zone 2"
setting to "Act" (Activated) as explained here.
1
Press the [RECEIVER] REMOTE
RECEIVER
MODE button, followed by the
[SETUP] button.
The main menu appears onscreen.
2
Use the Up and Down [
buttons to select "8. Hardware
Setup," and then press [ENTER].
ENTER
The Hardware Setup menu appears.
ENTER
3
Use the Up and Down [
buttons to select "Powered
Zone2," and use the Left and
ENTER
Right [
8.Hardware Setup
------------------------
a.PoweredZone2:NotAct
a.PoweredZone2:NotAct
b.TV Format
c.AM Freq. Step: 9kHz
d.Remote ID
ENTER
Not Act: ZONE 2 SPEAKERS termi-
nals not activated.
Act: ZONE 2 SPEAKERS terminals
activated.
When Act is selected and Zone 2 is
turned on, the speakers connected to the
ZONE 2 SPEAKERS terminals will
output sound, but the speakers con-
nected to the SURROUND BACK
SPEAKERS terminals will not. When
Zone 2 is turned off, even if Act is
selected, the surround back speakers
will work as normal.
4 Press the [SETUP] button.
Setup closes.
Note:
• This procedure can also be performed on the AV
receiver by using its [SETUP] button, arrow buttons,
and [ENTER] button.
]/[ ]
]/[ ]
]/[ ] buttons to select:
:Auto
:1

Using Zone 2

This section explains how to turn Zone 2 on and off, how
to select an input source for Zone 2, and how to adjust
the volume for Zone 2.
Controlling Zone 2 from the AV receiver
1 2
STANDBY/ON
STANDBY
ZONE 2
POWER
ON OFF
PURE AUDIO MULTI CH DVD VIDEO 1 VIDEO 2 VIDEO 3 VIDEO 4 PHONO
PHONES TUNING
ZONE 2 OFF TONE STEREO DIMMER MEMORY MODE SETUP
LISTENING MODE CLEAR PRESET
ZONE 2 LEVEL
1
To turn on Zone 2 and select an
input source, press the [ZONE 2]
ZONE 2
button repeatedly.
Alternatively, press the [ZONE 2]
button followed by an input
selector button within 8 seconds.
Zone 2 turns on, the ZONE 2 indicator
lights up, and the ZONE 2 12V TRIG-
GER OUT goes high (+12 V).
To select AM, FM, or XM (North
American model only), press the
[TUNER] input selector button repeat-
edly.
To select the same source as that of the
main room, press the [ZONE 2] button
repeatedly until "Zone 2 Sel: Source"
appears.
2 To turn off Zone 2, press the
OFF
ZONE 2 [OFF] button.
MASTER VOLUME
TAPE TUNER CD DISPLAY
VIDEO 4 INPUT
RETURN ENTER SETUP MIC
PRESET
TUNING DIGITAL S VIDEO VIDEO L AUDIO R
83