Setting The Multi Zone; Using Zone 2 - Onkyo DTR-40.2 Instruction Manual

Setting the Multi Zone

1
Press Receiver followed by Setup.
The main menu appears onscreen.
Tip
• If the main menu doesn't appear, make sure the appropri-
ate external input is selected on your TV.
2
Use / to select "Hardware Setup", and then
press Enter.
The "Hardware Setup" menu appears.
7. Hardware Setup
1. Remote ID
2. Multi Zone
3. Tuner
4. HDMI
5. Auto Power Down
6. Network
7. Firmware Update
3
Use / to select "Multi Zone", and then press
Enter.
The "Multi Zone" menu appears.
7-2. Multi Zone
Zone2 Out
Zone2 Maximum Volume
Zone2 Power On Volume
4
Use / to select an item, and use
it.
The items are explained below.
5
Press Setup.
The setup menu closes.
Note
• This procedure can also be performed on the AV receiver by
using Setup, arrows, and Enter.
■
Zone 2 Out
Fixed:
The Zone 2 volume must be set on the amp in that
zone.
Variable:
The Zone 2 volume can be set on the AV receiver.
If you've connected your Zone 2 speakers to an amp with
no volume control, set the "Zone 2 Out" setting, respec-
tively, to "Variable" so that you can set the volume, bal-
ance, and tone of zone 2 on the AV receiver.
■
Zone 2 Maximum Volume
Off, 50 to 99 (Absolute display)
Off, –32dB to +17dB (Relative display)
With this setting, you can limit the maximum volume for
Zone 2.
■
Zone 2 Power On Volume
Last, Min, 1 to 99 or Max (Absolute display)
Last, –
dB, –81dB to +18dB (Relative display)
This setting determines what the volume will be for
Zone 2 each time the AV receiver is turned on.
To use the same volume level as when the AV receiver was
last turned off, select "Last".
The "Zone 2 Power On Volume" cannot be set higher
En
than the "Zone 2 Maximum Volume" setting.
78

Using Zone 2

This section explains how to turn Zone 2 on and off, how
to select an input source for Zone 2, and how to adjust the
volume for Zone 2.
Controlling Zone 2 from the AV receiver
Zone 2
1
Fixed
Off
Last
/ to change
2
Note
• When Zone 2 is turned off, the output from the 12V TRIGGER
OUT goes low (0 volts).
Zone 2 indicator
Off
Input selector buttons
To turn on Zone 2 and select an input source, press
Zone 2 followed by an input selector button
within 8 seconds.
Zone 2 turns on, the Zone 2 indicator lights.
Tip
• 12V TRIGGER OUT goes high (+12 V).
To select AM or FM, press Tuner input selector and
Zone 2 repeatedly.
(North American models) You can also select SIR-
IUS.
To select the same source as that of the main room,
press Zone 2 twice. "Zone 2 Selector: Source"
appears on the display.
To turn off Zone 2, press Off.
The zone is turned off, and the Zone 2 indicator
goes off.