Zone 2; Setting The Powered Zone 2; Using Zone 2 - Onkyo TX-SR605 User Manual

Zone 2—Continued

Setting the Powered Zone 2

To use Zone 2, you must make this setting. It enables the
speakers connected to the ZONE 2 SPEAKERS termi-
nals so that they produce sound when Zone 2 is used.
1 Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
The main menu appears onscreen.
2
Use the Up and Down [
buttons to select "7. Hardware
Setup," and then press [ENTER].
The Hardware Setup menu appears.
3
Use the Up and Down [ ]/[ ]
buttons to select "2. Zone2," and
then press [ENTER].
The Zone2 menu appears.
4
Use the Left and Right [
buttons to select:
Not Act: ZONE 2 SPEAKERS termi-
When Zone 2 is activated and turned on
(see below), the speakers connected to
the ZONE 2 SPEAKERS terminals
output sound, but the speakers con-
nected to the SURR BACK SPEAK-
ERS terminals do not (when Zone 2 is
activated but not used, the surround
back speakers work as normal).
88
]/[
7. Hardware Setup
1. Remote Control
2. Zone2
3. Tuner
4. Analog Multich
5. HDMI
7–2. Zone2
Powered Zone2 Not Act
]/[
nals deactivated.
Act: ZONE 2 SPEAKERS termi-
nals activated.
5
Note:
This procedure can also be performed on the AV
receiver/AV amplifier by using its [SETUP] button,
arrow buttons, and [ENTER] button.

Using Zone 2

This section explains how to turn Zone 2 on and off, how
to select an input source for Zone 2, and how to adjust
the volume for Zone 2.
]
Controlling Zone 2 from the AV receiver/AV
amplifier
1 2
1
]
2
Press the [SETUP] button.
The setup menu closes.
To turn on Zone 2 and select an
input source, press the [ZONE 2]
button repeatedly.
Alternatively, press the [ZONE 2]
button followed by an input
selector button within 8 seconds.
Zone 2 turns on and ZONE 2 indicator
lights up.
To select AM or FM press the
[TUNER] input selector button repeat-
edly (TX-SR605 only).
To select the same source as that of the
main room, press the [ZONE 2] button
repeatedly until "Z2 Sel: Source"
appears.
To turn off Zone 2, press the
ZONE 2 [OFF] button.