Setting The Powered Zone 2/3 - Onkyo NR3007 - TX AV Network Receiver Instruction Manual

Multi Zone—Continued

Setting the Powered Zone 2/3

If you've connected your Zone 2/3 speakers to the AV
receiver, as explained in "Connecting Your Zone 2
Speakers Directly to the AV receiver" on page 131 or
"Connecting Your Zone 3 Speakers Directly to the AV
receiver" on page 133, you must set the "Powered
Zone2" or "Powered Zone3" setting to "Act" (Acti-
vated).
1 Press the [RECEIVER] button
followed by the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn't appear, make
sure the appropriate external input is
selected on your TV.
2 Use the Up and Down [ ]/[ ]
buttons to select "2. Speaker
Setup", and then press [ENTER].
The "Speaker Setup" menu appears.
3
Use the Up and Down [ ]/[ ]
buttons to select "1. Speaker
Settings", and then press
[ENTER].
The "Speaker Settings" menu appears.
134
2. Speaker Setup
1. Speaker Settings
2. Speaker Configuration
3. Speaker Distance
4. Level Calibration
5. Equalizer Settings
6. THX Audio Setup
2–1. Speaker Settings
Speaker Impedance 6ohms
Speakers Type(FrontA) Normal
Speakers Type(FrontB) Not Use
Powered Zone2 Not Act
Powered Zone3 Not Act
4
Use the Up and Down [ ]/[ ]
buttons to select "Powered
Zone2" or "Powered Zone3", and
use the Left and Right [ ]/[ ]
buttons to select:
Not Act:
ZONE 2/3 L/R speaker terminals
not activated (Powered Zone 2/3
disabled).
Act:
ZONE 2/3 L/R speaker terminals
activated (Powered Zone 2/3
enabled).
5 Press the [SETUP] button.
The setup menu closes.
Notes:
• Powered Zone2 cannot be used if "Speakers
Type(FrontB)" setting set to "Normal", "Bi-Amp" or
"BTL" (see page 58).
• Powered Zone3 cannot be used if "Speakers
Type(FrontA)" or "Speakers Type(FrontB)" setting
set to "Bi-Amp" or "BTL" (see page 58).
• This procedure can also be performed on the AV
receiver by using its [SETUP] button, arrow buttons,
and [ENTER] button.