Setting The Powered Zone 2 - Onkyo TX-SR653E Instruction Manual

Zone 2—Continued

Setting the Powered Zone 2

To use Zone 2, you must make this setting. It enables the
speakers connected to the ZONE 2 SPEAKERS termi-
nals so that they produce sound when Zone 2 is used.
7 8
+ 10
0
10
--/---
INPUT SELECTOR
MACRO
1 2
REMOTE MODE
1
RECEIVER DVD
TAPE/AMP
TV VCR
DIMMER
2
+
CH
DISC ENTER
ALBUM
-
PREV
CH
DISPLAY
REC PLAYLIST
LISTENING MODE
STEREO SURR
REPEAT AUDIO
DIRECT
TEST TONE CH SEL
OPEN/CLOSE VIDEO OFF
1 Press the [RECEIVER] button fol-
RECEIVER
lowed by the [SETUP] button.
The main menu appears onscreen.
2
Use the Up and Down [
buttons to select "0. Initial
Setup," and then press [ENTER].
ENTER
The Initial Setup menu appears.
ENTER
9
T V VOL
CLEAR
11 12
3 ZONE2
CD HDD
CABLE SAT
CDR MD
SLEEP
2, 3
VOL
1, 4
MUTING
RANDOM
SUBTITLE PLAY MODE
ALLST
LEVEL LEVEL
L NIGHT CINE FLTR
]/[ ]
3
Use the Up and Down [
buttons to select "g. Powered
Zone 2," and use the Left and
ENTER
Right [
Not Activated: Zone 2 SPEAKERS
terminals deactivated.
Activated: Zone 2 SPEAKERS termi-
nals activated.
When Zone 2 is activated and turned on
(see page 78), the speakers connected
to the ZONE 2 SPEAKERS terminals
output sound, but the speakers con-
nected to the SURROUND BACK
SPEAKERS terminals do not (when
Zone 2 is activated but not used, the
surround back speakers work as nor-
mal).
4
Press the [SETUP] button.
The setup menu closes.
Note:
This procedure can also be performed on the AV receiver
by using its [SETUP] button, arrow buttons, and
[ENTER] button.
]/[ ]
]/[ ] buttons to select:
77