FujiFilm FinePix S5 Pro Owner's Manual page 100

Adjusting Color Balance (T WHITE BALANCE)
Z Setting the preset white balance using WB and the
command dials
A While pressing WB, rotate the main-command dial until
PRE (preset) is displayed in the control panel.
B While pressing WB, rotate the sub-command dial to
select a preset custom number (P-1 to P-5).
C Remove your finger from WB and press
again for more than 1.5 seconds.
Preset recording mode is activated and
control panel. Also, the preset custom
number and PRE flash in the control panel.
D Hold up a sheet of white paper, etc., under
the target light source. Be sure the
whiteness fills the frame. Then press the
shutter button.
100
flashes in the viewfinder and the
E If the exposure is measured correctly,
the shutter speed display in the control panel, and
blinks in the shutter speed display in the viewfinder for
about 3 seconds. Then preset recording mode ends.
Z When the exposure is not measured correctly
When the exposure is not measured correctly,
blinks in the shutter speed display in the control panel
(exposure display in the viewfinder) for about 3 seconds,
then returns to the C step.
MEMO
The preset white balance cannot be set if:
- the memory card is full.
- the memory card has an error.
- is flashing.
- the frame number has reached 999-9999.
- is set in exposure mode
blinks in
.