Auto Reconnect Mode - Honeywell 1900GSR-2 User Manual

Auto Reconnect Mode

Auto Reconnect controls whether or not the scanner automatically begins
the relink process when a loss of connection is detected. When the Auto
Reconnect On bar code is scanned, the scanner begins the relink process
immediately, without user intervention. Default = Auto Reconnect On.
* Auto Reconnect On
Note: If you are connecting to a Bluetooth Interface Module, set Auto
Reconnect to Off.
The table below shows the results of the Auto Reconnect On and Off set-
tings:
Event
Scanner out of
range
Base or Access
point reset
(firmware upgrade
or power cycle)
3 - 28
Auto Reconnect On
Relink occurs
automatically. If
maximum number of link
attempts is
unsuccessful, then the
scanner must be
relinked by either pulling
the trigger, placing the
scanner in the base, or
scanning the Access
Point linking bar code.
(See Maximum Link
Attempts on page 3-29.)
Scanner behaves as if
out of range.
Auto Reconnect Off
Auto Reconnect Off
The scanner is
relinked by pulling the
trigger, or scanning
the Access Point
linking bar code.
No attempt to relink
made while base or
Access Point is
powered off. Trigger
must be pulled to
initiate relinking.