Alarm Sound Type - Honeywell 1900GSR-2 User Manual

code below and then set the time-out duration (from 0-3000 seconds) by scan-
ning digits on the
Save. Default = 0 sec (no alarm).
Base Alarm Duration
Note: The Access Point does not
have a base alarm.
Note: If you are out of range when you scan a bar code, you will receive an error
tone even if you do not have the alarm set. You receive the error tone
since the data could not be communicated to the base or Access Point or
the host.

Alarm Sound Type

You may change the alarm type for the scanner or base by scanning the
appropriate bar code below and then scanning a digit (0-7) bar code and
the Save bar code on the
manual. Default = 0.
The sounds are as follows:
Setting
0
1
2
3
4
5
6
7
Base Alarm Type
Note: The Access Point does not
have a base alarm.
3 - 14
Programming Chart
Programming Chart
Sound
3 long beeps, medium pitch
3 long beeps, high pitch
4 short beeps, medium pitch
4 short beeps, high pitch
single chirps, medium pitch
2 chirps, then 1 chirp, medium pitch
single chirps, high pitch
2 chirps, then 1 chirp, high pitch
inside the back cover, then scanning
Scanner Alarm Duration
inside the back cover of this
Scanner Alarm Type