Scanner Address; Base Or Access Point Address; Scanner Modes; Charge Only Mode - Honeywell 1900GSR-2 User Manual

Scanner Address

Scan the bar code below to determine the address of the scanner you are
using.

Base or Access Point Address

Scan the bar code below to determine the address of the base or Access Point
you are using.

Scanner Modes

The Xenon is capable of working in single scanner mode, multiple scanner
mode, or with Bluetooth devices other than the CCB01-010BT charge base or
Access Point.

Charge Only Mode

There may be times when you want to charge your scanner, but not link to
the base. For example, if a scanner is linked to an Access Point or other
Bluetooth device and you need to charge the scanner, but want to retain
your existing link.
In order to program the base for Charge Only Mode, you must link a scan-
ner to it. Once the scanner is linked to the base, scan the Charge Only
Mode bar code. Any subsequent scanners placed in that base will charge
without linking to it. The scanner used to program the base remains linked
to the base. To unlink this scanner, scan
Note: When in Charge Only Mode, the scanner periodically wakes up and
beeps. See "Power Up Beeper" on page 4-1 to change this setting.
Scanner Address
Base Address
Unlink Scanner
Charge Only Mode
on page 3-13.
3 - 11