Scanner Name - Honeywell 1900GSR-2 User Manual

To put the scanner in multiple scanner mode, scan the bar code below. Once
you scan this bar code, the scanner is unlinked from the base or Access Point
and must either be placed into the base, or you must scan the Access Point link-
ing bar code in order to relink.
Multiple Scanner Operation

Scanner Name

You may assign a name to each scanner you are using for identification pur-
poses. For example, you may want to have a unique identifier for a scanner that
is receiving imaging commands sent from the base or Access Point.
The default name for a Xenon is "Xenon." If you have more than one scanner
linked to a base, and they all have the same default name, the first scanner
linked to the base receives commands. When renaming a series of scanners
with identical default names, unlink all except one of the scanners from the
base.
Perform the rename operation using either the bar codes on page 3-23, or by
sending the serial command :Xenon:BT_NAM name . where name is the new
name for the scanner. If you wish to change the names of additional scanners,
link them one at a time and repeat the :Xenon:BT_NAM name . command for
each scanner.
3 - 22