Base Power Communication Indicator; Reset Scanner; Scanning While In Base Cradle - Honeywell 1900GSR-2 User Manual

Base Power Communication Indicator

To display the power indicator on a base or an Access Point, scan the Base
Power Communication Indicator On bar code. To turn off the power indi-
cator, scan the Off bar code. Default = On .
* Base Power Communication
Indicator On

Reset Scanner

Scanning this bar code reboots the scanner and causes it to relink with the
base or Access Point.

Scanning while in Base Cradle

Note: This feature does not apply to the Access Point.
If you want to be able to scan bar codes while the scanner is in the base cradle,
scan the Scanning in Cradle On bar code below. If you want to only allow
scanning when the scanner is out of the base cradle, scan Scanning in Cradle
Off. Default = Scanning in Cradle On .
Scanning in Cradle Off
3 - 8
Reset Scanner
Base Power Communication
Indicator Off
* Scanning in Cradle On