Table of Contents
Advertisement
Display assembly
Description
39.6-cm (15.6-in) High Definition (HD), light-emitting diode (LED) BrightView display assembly:
●
For use in Charcoal Grey computer models
●
For use in Ocean Drive computer models
●
For use in Sonoma Red computer models
●
For use in Luminous Rose computer models
●
For use in Pewter computer models
●
For use in Pacific Blue computer models
●
For use in Pearl Pink computer models
●
For use in Sweet Purple computer models
●
For use in Butter Gold computer models
Before removing the display assembly, remove the following components:
1.
Battery (see
2.
Service access cover (see
3.
Optical drive (see
4.
WLAN module (see
5.
Keyboard (see
6.
Top cover (see
7.
USB board (see
8.
Power connector (see
Remove the display assembly:
1.
Position the computer display-side up, with the front toward you.
2.
Open the display as far as possible.
3.
Disconnect the display panel cable (1) from the system board.
4.
Pull the antenna cables through the opening in the base enclosure (2), and then disengage the
cables from the clip in the routing channel leading to the display hinge.
CAUTION:
steps. Failure to support the display assembly can result in damage to the assembly and other
components.
5.
Remove the two Phillips 6.0×2.5 screws (3) that secure the display assembly to the computer.
ENWW
Battery on page
44)
Service access cover on page
Optical drive on page
WLAN module on page
Keyboard on page
53)
Top cover on page
56)
USB board on page
Power connector on page
Support the display assembly when removing the display screws in the following
45)
48)
50)
63)
64)
Component replacement procedures
Spare part number
645523-001
636378-001
645521-001
645522-001
645524-001
645525-001
645526-001
645527-001
645528-001
65
Advertisement
Table of Contents
