Table of Contents
Advertisement
5.
Remove the three Phillips 5.0×2.5 screws in the battery bay, the two Phillips 5.0×2.5 screws
near the hard drive connector, and the nine Phillips 6.0×2.5 screws along the edges of the base
enclosure.
NOTE:
enclosure.
6.
Lift the rear edge of the top cover (1) until the top cover disengages from the base enclosure.
Remove the top cover (2).
NOTE:
The TouchPad is glued to the top cover and is included with the top cover spare part.
Reverse this procedure to install the top cover.
58
Chapter 4 Removal and replacement procedures
The four screws along the front edge also serve to secure the speakers inside the base
ENWW
Advertisement
Table of Contents
