To Install The Hp Notebook Docking System Support - HP OmniBook 6000 - Notebook PC Evaluation Manual

Note
Using Windows 98
Using the Docking Solutions
Hot Swap is not supported in the Docking System module bay. You must restart the
OmniBook when changing modules in the Docking System module bay.
Hot Docking is not supported with an external video adapter is installed in the Docking
System. Always shutdown and turn off the OmniBook before docking or undocking the
OmniBook if you are using an external video adapter. Also do not suspend the
OmniBook while using an external video adapter. Power Management is not supported
with an external video adapter.

To install the HP Notebook docking system support

If you are going to use the HP Notebook Docking System you must install a new IDE
driver in Windows 98. Perform this procedure before inserting the HP Notebook into the
dock.
The HP Notebook Docking System IDE driver is located on the Recovery CD at
\HP\DRIVERS\W98\DOCKING\IDE and \HP\DRIVERS\W98\DOCKING\SCSI.
1. From the Start menu, click Run, and then enter
D:\HP\DRIVERS\W98\Docking\IDE\SETUP.EXE and click OK,
2. When prompted to install the CMD Bus Master IDE Driver, click Yes.
3. When prompted to restart, click No.
4. Open a DOS window and type the following:
D:
CD \HP\DRIVERS\W98\DOCKING
COPY HWP2280.INF C:\WINDOWS\INF /Y
CD SCSI
COPY SYMC8XX.INF C:\WINDOWS\INF /Y
COPY SYMC8XX.MPD C:\WINDOWS\SYSTEM\IOSUBSYS /Y
5. Close the DOS window and shut down the HP Notebook.
6. Insert the HP Notebook in the HP Notebook Docking System and power on the HP
Notebook.
7. Windows 98 will detect the "PCI standard PCI to PCI bridge". Click Next to
continue.
8. Click Next to Search for the best driver for your device.
110 Corporate Evaluator's Guide