To Install Hp Mobile Expansion Base Support - HP F2974KT - OmniBook 500 - PIII 700 MHz Manual

Using Windows NT 4.0
Installing Windows NT 4.0
34. Click Next to start "Installing Windows NT Networking".
35. Choose "Do not connect this computer to a network at this time". Windows NT
networking will be installed at a later time. Click Next to continue.
36. Select Finish to "Finish Setup".
37. Select the correct Time Zone and press Close.
38. Click OK on "Detected Display" then OK on "Display Properties". Do not change
settings at this time.
39. Remove any disc (NT CD) from the CD-ROM drive.
40. Click "Restart Computer".
*** Retail Windows NT 4.0 is now installed. ***
41. After booting to Windows NT 4.0, apply the Service Pack for Windows NT 4.0.
Note: Installation of Service Pack 4 or greater is necessary prior to loading certain device
drivers below. To do this:
Windows NT 4.0 drivers are available from the Windows NT 4.0 Driver Package
available at http:\\www.hp.com\omnibook. HP strongly recommends copying the NT4
Driver directory to the hard drive. Create a folder on the hard drive with the structure
C:\HP\DRIVERS\NT4 and copy the driver contents from the web, under this same path,
to this location. Copy the I386 directory from the Windows NT Workstation CD to the
root of the notebook hard drive (this will create an \I386 directory on the root).
To install Service Pack 6a:
1. Double-click on the file nt4_sp6a.exe. Select "Accept the License Agreement" and
click Install.
2. Click Restart.

To install HP mobile expansion base support

If you have installed retail Windows NT4 and have a mobile expansion base, you need to
install CMD drivers. The CMD drivers can be downloaded from
http://www.hp.com/omnibook.
To install or upgrade the CMD drivers:
1. Go to the Control Panel and select the SCSI Adapters icon.
2. Select the Drivers tab and click "Add".
128 Corporate Evaluator's Guide