To Replace The Hard Disk Drive Holder - HP OmniBook 6000 - Notebook PC Evaluation Manual

To replace the hard disk drive holder

If you are installing a new hard drive that does not have a cover, you can remove the
cover parts from the old hard drive. You'll need a small Phillips screwdriver for this
procedure.
1. Remove all six screws from the holder and drive case, then lift the drive out of the
holder.
2. Notice that the hard drive has a pin connector attachment at one end. Carefully
remove this connector from the end of the drive. Work alternately at each end so that
the connector slides off evenly without bending the connector pins.
3. Carefully put the pin connector attachment back onto the pins on the end of the new
hard drive. Work alternately at each end so that the connector slides on evenly
without bending the connector pins.
4. Insert the connector through the end of the holder, and lower the drive into the holder.
5. Reinstall all six screws into the holder and drive case. The thinner screws go nearest
the connector.
Configuring and Expanding Your Computer
Replacing a Hard Disk Drive
Corporate Evaluator's Guide 91