HP OmniBook 6000 - Notebook PC Evaluation Manual page 163

Hp omnibook 6000 - corporate evaluation guide
Hide thumbs Also See for OmniBook 6000 - Notebook PC:
Table of Contents

Advertisement

If a secondary battery doesn't charge
• The computer's secondary battery won't charge until the main battery is fully
charged.
• Make sure the ac adapter is fully plugged into the power source and the computer, and
that the light on the adapter is on.
• Make sure the secondary battery is correctly installed and locked in place.
If the computer has a short operating time
• Try conserving power using any of the suggestions listed in "To maximize battery
operating time" on page 50.
• If you are running an application that has an automatic save feature (such as
MS Word), disable this feature or increase the specified save time to reduce hard disk
access.
• If the operating time has gradually become shorter and the battery is more than a year
or two old, you may need to replace the battery.
• Heavy modem use can affect battery operating time.
• PC card use can affect battery operating time.
If the Time Remaining for the battery is not correct
• The Time Remaining is an estimate, not a precise value, and is based on the rate at
which the computer is using power at the moment. This value therefore depends on
your current task, and assumes that you will continue using power at the same rate
until the battery runs out. So, if you check the Time Remaining while the computer is
performing a task requiring a good deal of power (such as reading from a CD or
DVD), the value will probably show less time remaining than you really have, since
you will probably later switch to tasks that require less power.
If the computer doesn't suspend to Standby mode as expected
• If you have a connection to another computer, the computer won't suspend if the
connection is active.
• If the computer is performing an operation, it normally waits for the operation to
finish before suspending.
• For Windows 95, if a CD-ROM drive is present, make sure auto insert notification is
disabled (the default factory setting). This is not required for Windows 98 or 2000.
In Windows 95 or 98, view the CD-ROM drive properties in Device Manager.
Troubleshooting Your Computer
Troubleshooting Techniques
Corporate Evaluator's Guide
163

Advertisement

Table of Contents
loading

This manual is also suitable for:

Omnibook 6000

Table of Contents