Drying Time - Canon imagePROGRAF iPF825 MFP M40 User Manual

Note
• The settings in the Paper Detailed Settings dialog box are temporary; after the print job finishes the settings
of the printer operation panel are restored.

Drying Time

Between Pages
This sets the wait time for the ink to dry between each completely printed sheet and the output of the sheet.
Setting
Printer Default
None
30sec. / 1min. / 3min. / 5min. /
10min. / 30min. / 60min.
Between Scans
This sets the wait time between line scans during printing.
Setting
Printer Default
None
1sec. / 3sec. / 5sec. / 7sec. / 9sec.
Roll Paper Margin for Safety
Near End Margin
This sets the length of the near end margin of the roll paper.
Setting
Printer Default
3mm
20mm
Important
• If you make the margin (white space) too small, this could disturb the print image or cause the printhead to
scour the surface of some types of media. If the printhead scours the surface of the media, adjust the height of
the printhead.
Cut Speed
This selects the auto cut speed.
iPF825
The settings of the printer operating panel are applied.
The paper is ejected immediately after printing.
The sheet is ejected when the specified time after printing has elapsed.
The settings of the printer operating panel are applied.
The printing continues to the next line immediately after the last line.
The printing continues to the next line after the set time.
*For the media type that has problems, such as ink smears on the page or colors
that seem uneven during borderless printing etc., increase the value for this setting.
The settings of the printer operating panel are applied.
Print at a standard size.
*Select for Media Type that has no problem when printing with a standard size
margin.
This setting sets the margin about 17 mm (in the feed direction) longer than the
standard margin for the media size.
*This is for Media Type that has a strong tendency to curl, causing the printhead to
scratch the surface.
Windows Software
Details
Details
Details
Paper Detailed Settings
> HDI Driver >
4
387