Table of Contents
Advertisement
Failed to Install the Device Driver (when the USB is connected)
If the device driver cannot be installed while this unit is connected to the computer with a USB cable, make sure
to enable the USB port referring to the steps shown below.
1 1 1 1
Click the "Start" button, select "Settings", and then
click "Control Panel".
On Windows XP, click the "Start" button, click "Control
Panel", and then click "Performance and Maintenance".
2 2 2 2
Double-click the "System" icon and click the
"Device Manager" tab.
"Universal Serial Bus controllers" will appear in the list of
devices.
! If the "System" icon does not appear on Windows Me,
click "view all Control Panel options" to view it.
! On Windows 2000, double-click the "System" icon, click
the "Hardware" tab, and click the "Device Manager"
button.
! On Windows XP, click "System", click the "Hardware" tab,
and click the "Device Manager" button.
3 3 3 3
Click the ( ) icon beside the "Universal Serial Bus
controllers".
Two items will display, your Controller chipset type and
Root Hub. If these items appear, you can use USB port. If the
"Universal Serial Bus controllers" shows a yellow
exclamation point or does not appear, you must check your
computer manual for USB troubleshooting or contact your
computer manufacturer.
4 4 4 4
When you make sure that the USB port is enabled,
install the device driver, referring to "INSTALLING
THE SOFTWARE" in the Setup Guide and
Operation Manual.
Troubleshooting
77
Advertisement
Table of Contents
