Table of Contents
Advertisement
Button Manager Settings
After being installed, Button Manager normally keeps active under the Windows operating system. Follow the
steps shown below to set scan options as you like.
1 1 1 1
Right-click the Button Manager icon (
task bar.
If the Button Manager icon does not appear on the task
bar, click the "Start" button, select "Programs" ("All
Programs" on Windows XP), select "SHARP AJ-6110",
and then click "Button Manager" to start Button Manager.
2 2 2 2
Select "Settings" from the displayed pop-up menu.
The setting screen of Button Manager will open.
3 3 3 3
Click the tab of the scan menu you want to set up.
4 4 4 4
) on the
Set up the start-up application in the "Application
Selection" area.
Reference:
5 5 5 5
Set up the "Colour Mode", "Edge Enhancement"
and other scan settings in the "Scan Setup" area.
Reference:
6 6 6 6
Click the "OK" button.
You have completed the settings.
"Application Selection" Settings
"Scan Setup" Settings
! Ensure that Button Manager has been started before
using the "SCAN" button.
! You may experience slight problems on your computer
(e.g. skipping while playing audio CD or DVD, etc.) while
Button Manager is active. In this case, right-click the
Button Manager icon on the taskbar and then click
"Monitor" to remove the check mark. When the check
mark is removed, the "SCAN" button on the unit cannot
be used for scanning. If you need to use the "SCAN"
button for scanning, select "Monitor" once again.
Click "Monitor" to
2
remove the check
mark.
Button Manager
Right-click the Button
1
Manager icon to
display the menu.
58
Advertisement
Table of Contents
