When You Cannot Print - Ricoh SP 5200S Operating Instructions Manual

When You Cannot Print

This section describes what to do if printing does not start even after performing a printing operation.
Problem
Printing does not start.
Printing does not start.
Printing does not start.
Printing does not start.
Printing does not start.
Printing does not start.
Causes
The power is off.
The machine is set to
"Offline".
The cause is displayed on
the screen of the control
panel.
The interface cable is not
connected correctly.
The correct interface cable is
not being used.
The interface cable was
connected after the machine
was switched on.
When You Cannot Print
Solutions
Check the cable is securely plugged
into the power outlet and the machine.
Turn on the main power switch.
Press [ Online].
Check the error message or warning
status on the display panel, and then
take the required action.
Connect the interface cable securely. If
it has a fastener, fasten that securely as
well. See "Connecting to the Interface",
Network and System Settings
Reference.
The type of interface cable you should
use depends on the computer. Be sure
to use the correct one. If the cable is
damaged or worn, replace it. See
"Connecting to the Interface", Network
and System Settings Reference.
Connect the interface cable before
turning on the main power switch.
4
91