Other Messages - Ricoh SP 5200S Operating Instructions Manual

Message
"Updating the destination
list... Please wait. Specified
destination(s) or sender's
name has been cleared."
"You do not have the
privileges to use this
function."

Other Messages

This section describes likely causes of and possible solutions for the error messages that are printed on
the error logs or reports.
Message
"86: Error"
"91: Error"
"92: Error"
"98: Error"
Causes
The destination list is being
updated from the network
using Web Image Monitor.
The logged in user name
does not have permission for
the selected function.
Causes
Parameters of the control
code are invalid.
Printing was canceled by the
auto job cancel function due
to a command error.
Printing was canceled
because [Job Reset] or the
[Clear/Stop] key was
selected on the machine's
control panel.
The machine could not
access Hard disk correctly.
Messages Displayed When Using the Printer Function
Solutions
Wait until the message disappears. Do
not switch off the power while this
message is displayed. Depending on
the number of destinations to be
updated, there may be some delay
before you can resume operation.
Operations are not possible while this
message is displayed.
Contact your administrator about the
permission for the required function.
Solutions
Check the print settings.
Check that the data is valid.
Perform the print operation again if
necessary.
Turn off the main power switch, and
then back on again. If the message
appears frequently, contact your
service representative.
4
81