Messages Displayed When Using The Printer Function; Status Messages - Ricoh SP 5200S Operating Instructions Manual

Messages Displayed When Using the Printer
Function
This section describes the principal messages that appear on the display panel, error logs or reports. If
other messages appear, follow their instructions.

Status Messages

This section describes the machine status messages.
Message
"Hex Dump Mode"
"Job Suspended..."
"Offline"
"Please wait."
"Printing..."
"Ready"
"Resetting job..."
"Setting change..."
"Waiting for print data..."
In Hex Dump mode, the machine receives data in hexadecimal format.
Turn off the main power switch after printing, and then turn it back on.
Printing was temporarily stopped by SmartDeviceMonitor for Client.
You can resume printing via [My Job List] in SmartDeviceMonitor for
Client, or via the Web Image Monitor. To resume printing via Web
Image Monitor, check with your system administrator first.
The machine is offline. To start printing, switch the machine online by
pressing [ Online].
This message might appear for a second or two while the machine is
preparing, performing initial adjustments, or adding toner. Wait a
while.
The machine is printing. Wait a while.
This is the default ready message. The machine is ready for use. No
action is required.
The machine is resetting the print job. Wait until "Ready" appears on
the display panel.
The machine is changing settings. You cannot use the control panel
while this message is displayed. Wait a while.
The machine is waiting for the next data to print. Wait a while.

Messages Displayed When Using the Printer Function

Status
4
77