Noise Reduction Settings - Vox Tonelab ST Owner's Manual

Modeling effect processor
Hide thumbs Also See for Tonelab ST:
Table of Contents

Advertisement

Adjusting the high-frequency tone (Presence)
Hold down the CABINET on/off switch for about one sec-
ond to enter OPTION parameter setting mode, and then
turn the TREBLE control.
5.
Select and adjust the effects of other sections.
For example if you want to add delay, turn the MOD/
DELAY selector to select DELAY.
If the selector is already positioned at DELAY, turn it to
some other delay type and then back to re-select DELAY.
Use the TAP switch or EDIT knob to set the delay time, delay
level (the mix amount of delay sound), and feedback.
To set the delay time
Press the TAP switch twice (the time will be set to the
interval at which you press the switch).
To adjust the delay level or feedback
Delay level: Turn the EDIT knob.
Feedback: Hold down the TAP switch and turn EDIT.
For details on the effect types, refer to "Effect types" (p.18).
HINT: If you've selected a pedal effect, it might be easier to
make adjustments if other effects are not being applied. If so,
adjust the pedal effect after you've specified the amp model
and cabinet model, but before you make settings for other
effects.
6.
When you've come up with a sound that you like, save it as
a program.
For details, refer to "Saving a program" (p.12).
NOTE: If you switch to a different program or turn off the
power before saving, the changes you've made will be dis-
carded, and the settings will revert to their original state.
Parameter original value indication
This is a way for you to check the original value of a parame-
ter; i.e., the value that was saved in the preset program or user
program.
When you're using a knob to edit the value of a parameter, the
decimal point in the lower left of the program display LED is lit
momentarily when the edited value matches the original value.
HINT: You can take advantage of this original value indica-
tion to find out the actual settings of a program that you like.
NOTE: The settings of the rear panel LEVEL knob and AMP/
LINE switch are not saved, and will not be shown by the orig-
inal value indication. Nor will the original value of the
SPEED parameter or TIME parameter be shown when you
use the TAP switch to set the SPEED parameter or TIME
parameter.

Noise reduction settings

Noise reduction reduces the unwanted noise that might be
heard between notes. This setting is made independently for
each program.
HINT: High-gain amp models are particularly prone to noise,
so we recommend using noise reduction in this case.
1.
Hold down the CABINET on/off switch for about one sec-
ond to enter OPTION parameter setting mode.
The CABINET on/off switch LED will blink.
2.
Turn the MIDDLE control to adjust the noise reduction sen-
sitivity.
11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents