Vox Tonelab ST Owner's Manual page 7

Modeling effect processor
Hide thumbs Also See for Tonelab ST:
Table of Contents

Advertisement

b. CABINET ON/OFF switch and LED
This turns the cabinet model on/off. The LED will be lit if the
cabinet model is on.
By entering OPTION parameter setting mode you can set
parameters for the cabinet model.
OPTION parameter setting mode
To enter OPTION parameter setting mode, hold down the CAB-
INET ON/OFF switch for about one second. You'll be in
OPTION parameter setting mode, and the LED will blink.
OPTION parameter setting mode lets you make the following
settings.
• GAIN control: cabinet model (CABINET)
• TREBLE control: presence (PRESENCE)
• MIDDLE control: noise reduction (NR)
When you return to the previous operation, press the CABINET
ON/OFF switch or the EXIT/TUNE switch.
NOTE: In OPTION parameter setting mode, the BASS and
VOLUME controls are disabled in this mode.
c. AMP selector
This selects the amp model.
The amp model you select will determine the response of the
gain circuit and tone controls, and the order in which they are
located in the circuit.
If the amp model is turned off, turning this selector will turn the
amp model on.
d. GAIN control
This adjusts the gain of the selected amp model. In OPTION
parameter setting mode, this control selects the cabinet model.
If the cabinet model is turned off, turning this control in
OPTION parameter setting mode will turn the cabinet model on.
e. TREBLE, MIDDLE, BASS controls
These adjust the tone of the high, mid, and low frequency
ranges. In OPTION parameter setting mode, the TREBLE control
adjusts the presence and the MIDDLE control adjusts the noise
reduction.
The way in which these controls affect the tone will depend on
the amp model you've selected.
NOTE: Depending on the selected amp model, there may be
almost no sound if you turn all three of these controls to the
far left.
f. VOLUME control
This adjusts the volume of the program.
HINT: You can adjust the volume of the program even when
the amp model is turned off.
2. Pedal section
Here you can make settings for the pedal
effects.
For details on each effect, refer to "Pedal
types" (p.18).
a. PEDAL ON/OFF switch and LED
This turns the pedal effect on/off. The
LED will be lit if the pedal effect is on.
3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents