Making Connections - Vox Tonelab ST Owner's Manual

Modeling effect processor
Hide thumbs Also See for Tonelab ST:
Table of Contents

Advertisement

Making connections

Here's how to make connections and start using your ToneLab ST.
Mixer, recorder, etc.
1.
Set the AMP/LINE switch appropriately for the type of
device you'll be connecting to the OUTPUT/PHONES jack.
Set the AMP/LINE switch as follows.
AMP (VOX, F, M)
If you're connecting a guitar amp, choose the VOX, F, or M
setting. This setting will compensate the output from the
amp model as necessary. However, compensation will not
be applied if the amp model is off.
• VOX: Use this setting if the output is connected to an amp
that has a distinctive mid-range such as the AC30 open-
backed combo amp made by the VOX Corporation.
• F: Use this setting if the output is connected to a typical
clean-sounding US-made open-backed combo amp.
8
Guitar amp
Headphones
Audio system
VOX
CD player, etc.
AUX
OUTPUT/PHONES
INPUT
IN
• M: Use this setting if the output is connected to a stack-
type amp such as a 4x12 closed-back cabinet.
LINE
Use this setting if the output is connected to your guitar
amp's power amp, to an audio system, mixer, or recorder,
or to headphones.
2.
Use a cable to connect the ToneLab ST's OUTPUT/PHONES
jack to your guitar amp, mixer, or other device.
NOTE: Lower the volume of your guitar amp or mixer before
you make connections.
The OUTPUT/PHONES jack is a stereo output. Use a phone
plug to make connections.
Guitar
Computer
AC adapter
USB cable
DC12V
USB

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents