b. PEDAL controller
This selects the pedal type.
If the pedal effect is turned off, turning this selector will turn the
pedal effect on.
c. EDIT knob
This adjusts the parameters of each effect.
3. MOD/DELAY section
Here you can make settings for the mod-
ulation effect, delay effect, and other
effects such as pitch shift.
For details on each effect, refer to
"Mode/Delay types" (p.20).
a. MOD/DELAY ON/OFF switch and
LED
This turns the modulation effect, delay effect, or other effect on/
off. The LED will be lit if the effect is on.
b. MOD/DELAY selector
This selects the modulation type, delay type, or other effect type.
If the effect type is off, turning this selector will turn the effect
type on.
c. EDIT knob
This adjusts the parameters of each effect.
You can use this knob to adjust two different parameters, EDIT 1
or EDIT 2. The specific parameters that are adjusted will depend
on the selected effect. For details, refer to "Mode/Delay types"
(p.20).
• EDIT 1: turn the EDIT knob
4
• EDIT 2: hold down the TAP switch and turn the EDIT
knob
d. TAP switch and LED
This is used to set the speed of the modulation effect or the delay
time of the delay effect. The interval at which you press the TAP
switch twice is assigned as the time.
The LED will blink to indicate the specified speed or time.
If you've selected PITCH SHIFTER, the pitch setting will change
each time you press the TAP switch.
If you've selected FILTRON, the envelope up/down setting will
change each time you press the TAP switch. The LED will light if
Up is selected.
You can edit parameters such as SPEED or PITCH by holding
down the TAP switch and turning the EDIT knob (EDIT 2). For
details, refer to "Mode/Delay types" (p.20).
4. Reverb section
Here you can make settings for the reverb effect.
For details on each reverb effect, refer to "Reverb
types" (p.22).
a. REVERB ON/OFF switch and LED
This turns the reverb effect on/off.
The LED will be lit if the reverb effect is on.
b. REVERB knob
Depending on the position of the knob, this selects the reverb
type (SPRING, ROOM, or HALL) and adjusts the mix amount of
the reverb sound.
If the reverb effect is off, turning this knob will switch the reverb
effect on.