Adjusting The Sensitivity Of The Expression Pedal - Vox Tonelab ST Owner's Manual

3.
Use the VOLUME control to specify the maximum value,
and then press the EXP PARAM switch.
The maximum value will be specified; the program dis-
play will indicate "
then indicate the program number.

Adjusting the sensitivity of the expression pedal

If the minimum and maximum values of the parameter are
assigned as the minimum and maximum values of the expres-
sion pedal, but the effect or volume fails to reach the maximum
(or minimum) setting when the expression pedal is fully
advanced (or returned), you can adjust the sensitivity of the
expression pedal as follows so that it will operate optimally.
NOTE: When adjusting the sensitivity, you must operate the
expression pedal with your foot; in some cases, it may not be
possible to adjust the pedal sensitivity if you operate it with
your hand.
1.
Turn the power off.
2.
While holding down the EXP PARAM switch and WRITE
switch, turn the power on.
3.
When the program display indicates "
switches.
4.
Advance the expression pedal so that
the effect switches on/off.
This will be assigned as the weight that
will switch on/off the effect assigned to
the expression pedal.
" for about one second, and will
," release the
5.
Use your foot to slowly return the
expression pedal toward yourself, and
take your foot off when the pedal stops.
6.
Softly advance the expression pedal,
and take your foot off when the pedal
stops.
NOTE: If you decide to cancel this sensitivity adjustment,
press the EXIT/TUNE switch.
7.
Press the WRITE switch.
The program display will indicate "
second, and then the program number will appear.
If the sensitivity adjustment could not be performed correctly,
the program display will blink "
" ". In this case, perform the procedure from step 4.
NOTE: If you are repeatedly unsuccessful in adjusting the
sensitivity, it is possible that the ToneLab ST has malfunc-
tioned. Please contact your nearby VOX dealer.
" for about one
", and will then indicate
27