Creating Your Own Sounds; Creating A Sound - Vox Tonelab ST Owner's Manual

Modeling effect processor
Hide thumbs Also See for Tonelab ST:
Table of Contents

Advertisement

Creating your own sounds

There are two ways to create your own sound: you can start with
a program that's similar to what you have in mind and then edit
the parameters as desired, or you can create a program from
scratch.

Creating a sound

Here we'll explain how to create a program from scratch.
1.
Turn off the cabinet model and effect types.
If the CABINET on/off switch, MOD/DELAY on/off
switch, and REVERB on/off switch LEDs are lit, press each
switch to turn them off.
10
2.
Press the AMP bank select switch to select a bank, and use
the AMP selector to select an amp model.
Each time you press the AMP bank switch, the bank will
cycle through STD (Standard), SPL (Special), CST (Cus-
tom), STD ...
For details on the amp models, refer to "Amp models"
(p.13).
3.
Use the GAIN, TREBLE, MIDDLE, BASS, and VOLUME
controls to adjust the tone and volume.
The GAIN control adjusts the gain.
The TREBLE, MIDDLE, and BASS controls adjust the high,
mid, and low-frequency tone.
The VOLUME control adjusts the volume.
HINT: The sound might be distorted in an undesirable way
depending on the settings of the TREBLE, MIDDLE, or BASS
controls, or depending on other settings. If so, adjust the
VOLUME control to an appropriate volume.
4.
If desired, select a cabinet model and adjust the high-fre-
quency tone.
To turn the cabinet model on
Press the CABINET on/off switch. The LED will light.
To change the cabinet mode
Hold down the CABINET on/off switch for about one sec-
ond to enter OPTION parameter setting mode (the CABI-
NET on/off switch LED will blink). Then turn the GAIN
control.
For details on the cabinet models, refer to "Cabinet models"
(p.17).

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents