Trying Out The Programs - Vox Tonelab ST Owner's Manual

Modeling effect processor
Hide thumbs Also See for Tonelab ST:
Table of Contents

Advertisement

If you use a monaural phone plug cable to connect this to
your amp etc., only the sound of the L (left) channel will be
output.
If you want to connect this in stereo to a mixer or recorder,
use a "stereo phone plug (output) -> monaural phone plug x
2 (input)" adapter cable.
3.
Turn the rear panel LEVEL knob to "0" (all the way to the
left as seen from the rear panel).
4.
Connect the plug of the included AC
adapter to the DC12V jack, and plug the AC
adapter into an AC outlet.
Wrap the AC adapter cable around the
cable hook.
5.
Connect the cable from your guitar to the
INPUT jack.
6.
Make sure that the volume of your amp or mixer is turned
down, and then turn the STANDBY switch on.
7.
Raise the volume controls of your amp or mixer, and turn
the rear panel LEVEL knob to adjust the volume.
NOTE: Since the ToneLab ST uses a vacuum tube, there
might not be sound for a few seconds until the vacuum tube
has warmed up.

Trying out the programs

The ToneLab ST has a total of one hundred programs, consisting
of rewritable user programs (No.0–49) and preset programs
(No.50–99).
For details on the preset programs, refer to "Preset program list"
(p.31).
1.
Press the UP or DOWN pedal to switch programs.
Play your guitar, and try out the various programs.
Each program contains settings that assign the expression
pedal to control wah, volume, delay feedback, reverb input
level, or some other effect parameter. Operate the expression
pedal to try out the assignment for each program.
HINT: To increment the program number by 10, hold down
the UP pedal and press the EXIT/TUNE key. Similar, to dec-
rement the program number by 10, hold down the DOWN
pedal and press the EXIT/TUNE key.
9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents