Tuner; Tuning Procedure; Calibrating The Tuner - Vox Tonelab ST Owner's Manual

Modeling effect processor
Hide thumbs Also See for Tonelab ST:
Table of Contents

Advertisement

Tuner

The ToneLab ST has a built-in auto chromatic tuner.

Tuning procedure

1.
If you want to tune with the effects bypassed, press the UP
pedal and DOWN pedal simultaneously.
The program display will indicate "
HINT: If the QUICK ASSIGN LED or the program display are
not blinking, you can also press the EXIT/TUNE switch to
tune with the effects bypassed.
If you want to tune with the sound muted, hold down
the UP pedal and DOWN pedal simultaneously for
about two seconds.
The program display will indicate "
second, and will then indicate "
stage, we recommend that you use this method.
2.
Play a single note on your guitar, and tune the string
approximately so that the desired note name appears in the
program display.
The note name is shown as follows.
C
C
D
D
E
3.
While watching the LEDs of the program section and tuner
section, tune the guitar string precisely.
".
" for about one
". If you're tuning on
F
F
G
G
A
A
B
Tune so that only the center LED is lit.
The LEDs at the right will light if the pitch of your guitar is
sharp, and the LEDs at the left will light if it is flat.
4.
When you've finished tuning, press the UP or DOWN pedal.
HINT: You can also press the EXIT/TUNE switch to return to
the previous operation.

Calibrating the tuner

Calibration specifies the reference pitch for tuning (expressed as
the frequency of the middle 'A' note on a piano). You can adjust
this in a range of 438 Hz–445 Hz.
NOTE: The calibration setting you specify here will be dis-
carded when you turn off the power. When you turn the
power on again, it will automatically be set to 440 Hz.
1.
Activate the tuner as described in step 1 of "Tuning proce-
dure" (p.23).
2.
While holding down the EXIT/TUNE switch, use the UP/
DOWN pedals to adjust the reference pitch.
The program display will indicate "38"–"45" (438 Hz–445
Hz). Specify the desired reference pitch.
3.
Release the EXIT/TUNE switch to complete the calibration setting.
23

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents