Advertisement
How to Enter a Product Name in a Test Menu
1. Enter the program mode. See How to Enter the Program Mode on Page 3-10.
2. Press the
switch to select Test Menu 1 or 2.
3. Press the
switch to enter the edit mode. The right display will show EDIT and a blinking
cursor will appear in the left display.
4. To enter a letter, use the left
DOWN in the alphabet.
NOTE: Characters available are the letters A-Z and the numbers 0-9. Special characters *, *, -,
?, and / are also available, as is a blank space.
NOTE: Pressing the left
5. To move to a different character position, use the
6. To EXIT and SAVE the product name entry, press the
display, followed by YES or NO, indicating whether the menu item is active or not. Press the
right
or
switch to toggle between yes and no.
1
2
7. Press the
switch to cycle through the Duty Times, Pull Time, QA (hold) Time, and Cooking
Temperature Setpoint settings. Program the times and the set point in accordance with the section
that follows.
How to Program Duty Times, Pull Time, QA Time, and Setpoint for a Test Menu Item
NOTE: Duty Time refers to an operator-specified time within a cooking cycle when the computer
will sound an alarm to prompt a particular duty such as shaking the basket.
1. Enter the program mode. See How to Enter the Program Mode on Page 3-10.
2. Press the
switch to select the desired test menu.
3. Press the
switch. DUTY1 will appear in the left display. The currently programmed time
appears in the right display. To program the time, use the following switches:
Press the right
2
automatic alarm cancel mode (AUTO).
NOTE: In the automatic alarm cancel mode (AUTO), when the programmed time has elapsed,
an audible alarm will sound three times and then stop. In the manual alarm cancel mode (MAN),
switch to go UP in the alphabet. Use the left
1
switch will reset the product name to the factory defaults.
Left
Minutes (in increments of ten)
Left
Minutes (in increments of one)
1
Left
Seconds (in increments of ten)
2
Right
Seconds (in increments of one)
1
switch to toggle between the manual alarm cancel mode (MAN) and the
or
switches.
switch. SAVE will flash in the right
3–12
switch to go
2
Advertisement
