Advertisement
3.1
Equipment Setup and Shutdown Procedures
Setup
Fill the frypot to the bottom oil level line with vegetable oil before pressing the
ON/OFF switch
1. Fill the frypot with vegetable oil to the bottom OIL LEVEL line located on the rear of the frypot.
This will allow for oil expansion as heat is applied. Do not fill cold oil any higher than the bottom
line; overflow may occur as heat expands the oil.
2. Ensure that the power cord(s) is/are plugged into the appropriate receptacle(s). Verify that the
face of the plug is flush with the outlet plate, with no portion of the prongs visible.
3. Ensure that the vegetable oil level is at the top OIL LEVEL line when the vegetable oil is at its
programmed cooking temperature. It may be necessary to add vegetable oil to bring the level up
to the proper mark, after the oil has reached the programmed cooking temperature.
Do not add vegetable oil to the fryer between the time the computer is turned on and
the time it reaches programmed cooking temperature. Doing so is likely to cause
RECOVERY LOCKOUT (REC LOCK). See Section 3.4.
Shutdown
1. Press the ON/OFF switch
2. Filter vegetable oil and clean fryers.
3. Place the frypot covers on frypots.
3.2
Finding Information
How do I...
Activate/deactivate the BOIL-OUT mode?
Change computer product/temp displays?
Change cooking temperature setpoint?
Calibrate computer to frypot temperature?
Change shake, pull, or quality times?
Change the display language?
Configure the computer for a gas fryer?
Configure the computer for full- or split-vat?
Display Product Cycle Accumulator info?
CHAPTER 3: OPERATING FRYERS
WITH M100B™ COOKING COMPUTERS
to the ON position. Failure to do so could damage the frypot.
to the OFF position (the display will show OFF).
Page
3-10
3-9
3-11
3-9
3-10
3-8
3-8
3-9
3-14
WARNING
CAUTION
How do I...
Display "use time" information?
Enter a product number in a test menu?
Enter the program mode?
Enter the setup mode?
Program test item parameters?
Reset the computer to factory defaults?
Suppress a shake, QA, or duty function?
Turn factory-programmed menu item on/off?
Use the filter countdown time?
3–1
Page
3-14
3-12
3-8
3-8
3-12
3-10
3-13
3-14
3-15
Advertisement
