Adding Routes For Vpn Tunnel Clients - NETGEAR ProSafe SSL312 Reference Manual

.
Figure 9-1

Adding Routes for VPN Tunnel Clients

The Add Routes for VPN Tunnel Clients section allows you to define the addresses of devices
on your local network. Client routes are only required if the client address range is in a different
subnet then the corporate network or if your network has multiple subnets. Client routes inform the
VPN Tunnel Clients that other networks are located across the VPN over SSL tunnel by:
• The first VPN Tunnel Client assumes that addresses in the same subnet as the client IP address
(PPP interface) are located across the VPN over SSL tunnel.
• The address range in the client subnet. The specific subnet is determined by the class of the IP
address.
– Addresses between 1.0.0.0 and 126.255.255.255, are Class A addresses; the VPN Tunnel
Client will assume that all addresses with the same first octet are located across the VPN
tunnel.
VPN Tunnel Client
NETGEAR ProSafe SSL VPN Concentrator 25 SSL312 Reference Manual
v1.0, August 2006
9-3