Table of Contents
Advertisement
Warning Description Tables
If a problem is detected immediately after the power is turned on, or during operation, this will be indicated by the WARNING
lamp, lamps inside the viewfinder and a warning tone.
Note
The WARNING lamp has the highest priority, followed by the tally lamp, and then the warning tone. When multiple errors occur
simultaneously a higher priority indication will be triggered. The [9. Low Wireless Signal Reception], however, may not be
indicated, depending on the menu setting.
1. System Errors
Display window
The error code lights up.
indication
Blinks 4 times per second.
WARNING lamp
Blinks 4 times per second.
Tally lamp
The SYSTEM ERROR indication and the error
Viewfinder
code light up.
Beeps continuously.
Warning tone
An error in the reference signal or the
Warning
communication.
description
Recording/
The operation stops.
playback
operation
Please confirm [Error Codes] (page 155) and
Countermeasures
consult your distributor.
2. Card removal error
Display window
Error code E-30 blinks.
indication
Blinks 4 times per second.
WARNING lamp
Blinks 4 times per second.
Tally lamp
The "TURN POWER OFF" indicator lights up.
Viewfinder
Continues to beep.
Warning tone
The P2 card being accessed has been
Warning
removed, resulting in an error in the internal
description
memory of the camera-recorder.
Recording/
Cannot be performed.
playback
operation
Turn off the power to the camera-recorder. If
there is an error in a clip on the removed P2
Countermeasures
card, repair the clip.
Warning System
3. Battery Empty
Display window
indication
WARNING lamp
Tally lamp
Viewfinder
Warning tone
Warning
description
Recording/
playback
operation
Countermeasures Replace the battery.
4. P2 Card Fully Recorded
Display window
indication
WARNING lamp
Tally lamp
Viewfinder
Warning tone
Warning
description
Recording/
playback
operation
Countermeasures
All 7 bar indicators for battery remaining
capacity start blinking.
Lights up.
Blinks once per second.
The BATT LED lights up.
Beeps continuously.
The battery has run out.
The operation stops.
All 7 bar indicators for remaining MEDIA
capacity start blinking.
This lamp will illuminate continuously until an
operation is made after recording.
This lamp will flash 4 times every second until
an operation is made after recording.
The END indicator blinks.
This tone will sound continuously until an
operation is made after recording.
The P2 cards are recorded to maximum
capacity.
The recording stops.
Delete the clips in the P2 card or insert a new
P2 card.
Maintenance and Inspections: Warning System
153
Advertisement
Table of Contents
