Table of Contents
Advertisement
Setting Data Using an SD memory card
An SD memory card (optional accessory) can be used as a
setup card that stores up to eight files of settings menu
specifications.
This data allows you to quickly reproduce an optimum state.
> <Cautions in using SD memory cards> (page 22).
Handling SD memory cards
An SD memory card may be inserted or removed, either before or after the power is turned on.
To insert an SD memory card
Open the slot cover, and insert an SD memory card (optional
accessory) into the SD memory card slot with the notch
upward. Close the slot cover.
Note
An SD memory card must be inserted with the right side facing
the slot. If the card is hard to insert, it may be reversed or
upside down. Do not force it into the slot. Check the card
before re-inserting it.
Formatting, Writing and Reading an SD memory card
To format an SD memory card, write settings data or read
data on an SD memory card, navigate the menu to the <SD
CARD READ/ WRITE> screen from the FILE page.
# < SD CARD READ/WRITE >
R.SELECT
:1
READ
W.SELECT
:1
WRITE
CARD CONFIG
TITLE READ
TITLE:
1: ********
5: ********
2: ********
6: ********
3: ********
7: ********
4: ********
8: ********
To remove the SD memory card
Open the slot cover, and ensure that the BUSY lamp is not
illuminated. Then, further depress the SD memory card
towards the main unit. This releases the SD memory card
from the insertion slot. Take hold of the SD memory card and
remove it. Close the slot cover.
SD memory cards must not be used or stored in an
environment where they may be
Exposed to high temperatures/humidities;
Exposed to water droplets; or
Electrically charged.
For storage, the SD memory card must be kept inserted into
the unit with the lid closed.
If an SD memory card that is formatted in a standard other
than the SD standards and SDHC standards, [FORMAT
ERROR] is displayed in the top right section of the window.
In this case, reformat the card as follows. Note that the
indication "FORMAT ERROR" does not disappear if the SD
memory card is replaced with this menu page open. When
the SD memory card is replaced, perform TITLE READ.
Adjustments and Settings for Recording : Handling data
91
Advertisement
Table of Contents
