Step 13- Pole To Frame Assembly; Step 14- Rubber End Cap Assembly - Baby Lock Pearl BLQF Assembly Instructions Manual

Steps 13 & 14
Pole to Frame Assembly
Take-Up Pole
Rubber End Cap Assembly
Quilt-Top Pole
Backing Pole
Batting Storage Pole
Fig. 13-1
Step 13: Pole to Frame Assembly
Parts needed
1-Frame Assembly
1-Batting Storage Pole
1-Quilt-Top Pole
1-Backing Pole
1-Take-up Pole
13-1: Place the poles on the frame as shown
in Fig. 13-1. The poles will snap past the
plastic fingers, which are shown in Detail
8-2a.
Step 14: Rubber End Cap Assembly
Parts needed
1-Frame Assembly with Poles
Rubber End Cap
8-Rubber End Caps
14-1: Slide one (1) rubber end cap onto
the end of each bolt sticking out of the pole
ends, as shown in Fig. 14-1. If the poles
are assembled properly, there should be
approximately 3/8" to ½" of metal threads
showing beyond the ends of the pole.
Fig. 14-1
26