Step 8- Ratchet Stop Assembly - Baby Lock Pearl BLQF Assembly Instructions Manual

Step 8
Ratchet Stop Assembly
Step 8: Ratchet Stop Assembly
Parts needed
1-Open-hole Pole Bracket (right)
3-M6x48mm Socketed Washer Head Cap Screw
QF09318-204
3-Ratchet-Stop
3-Ratchet-Stop Bushing
3-Ratchet-Stop Mount
3-Ratchet-Stop Holder
Tools Required
4mm Allen Wrench (Provided)
8-1: Identify the open-hole pole bracket (right
bracket) and the plugged-hole pole bracket (left
bracket). Set the plugged-hole pole bracket
aside at this time. (Fig. 8-1)
8-2: Place one ratchet-stop catch between the
two metal pieces at the back of the open-hole
pole bracket, with the stop nub facing inside,
as shown in Fig. 8-1 and Details 8-1a,
8-1b, and 8-1c found on the next page. If the
ratchet-stop holder will not fit, loosen the two
bearing screws nearest the square hole. Slide
in the ratchet-stop holder and re-tighten when
finished.
18
QF09318-204 Screw
Fig. 8-1
8-4: Following the parts order shown in
Fig. 8-1, thread one M6 x 48mm QF09318-204
through a ratchet-stop, ratchet-stop bushing,
pole bracket (with ratchet-stop holder inserted)
and finally into the ratchet-stop mount. Pay
close attention to the orientation of the ratchet-
stop. Tighten with the 4mm Allen wrench until
the ratchet-stop-holder nub holds the ratchet-
stop.
8-5: In same manner, attach the remaining
ratchet-stops and ratchet-stop catches to the
front of the pole bracket, paying attention to
the orientation of the ratchet-stops (Figure
8-1, Details 8-1a, Details 8-1b and 8-1c)
to create the right pole bracket.
Stop
Holder
Mount
Bushing