Step 7- Track Assembly - Baby Lock Pearl BLQF Assembly Instructions Manual

Step 7
Track Assembly
Place the track support
upside down with the lip
toward the outside of the
table.
Track Support shown upside down.
Step 7: Track Assembly
Parts needed
1-Frame Assembly
4-Track Support
2-Track Support Couple
12- M5x8mm Socketed Button Head Cap Screw
QF09318-304
12-M6x12mm Socketed Washer Head Cap
Screw QF09318-303
4- Black Track
Tools Required
3mm Allen Wrench (provided)
4mm Allen Wrench (provided)
7-1: Place the four (4) track supports,
removed earlier, on the frame assembly top
with the screw holes up and the wide lip of the
supports facing the outside of the table.
(Fig. 7-1)
7-2: Check inside the ends of the track
supports for burrs or debris and remove all
foreign matter from the inside.
Third Hole for
stop screws
Second Hole
First Hole
Stop Screws M5 x 8mm SBHCS QF09318-304
in Third Hole
Fig. 5-2
QF09318-02
End Section
7-3: To prepare for joining the sections
together, screw one M5x8mm QF09318-304
into the third hole from the splice end of each
section to serve as a stop screw. (Figs. 7-1,
7-2) Fully tighten the screw with the 3mm
Allen wrench. This will help align the coupler
properly into the two track support sections
when joined.
7-4: Insert a coupler into one prepared end of
one track support section up to the stop screw.
Thread an M5x8mm QF09318-304 into the first
hole and lightly tighten as shown in Fig. 7-2.
QF09318-02
Fig. 7-1
Fig. 5-1
First Hole
QF09318-02
Coupler
End Section
Fig. 5-3
Fig. 7-2
15