Table of Contents
Advertisement
Steps 15 & 16
Bungee Clamp Assembly
Hook & Loop Tape on Pole Assemblies
Step 15: Bungee Clamp Assembly
Parts needed
1- Frame Assembly
4- Bungee Clamps QF09318-110
15-1: Thread the bungee clamp cord from the
inside of the frame through the bungee slot and
then pull the cord in a downward movement to
lock the bungee clamp into place. (Fig. 15-1)
15-2: Follow Step 14-1 for the remaining
three bungee clamps.
Step 16: Hook & Loop Tape on Pole
Assemblies
Parts needed
1-Frame Assembly
1-Quilt Top Pole
1-Backing Pole
1-Take-up Pole
3- Hook & Loop Tapes QF00665
Tools Required
Measuring Tape or Ruler (Not Provided)
Scissors (Not Provided)
NOTE: Take care to stick the hook & loop tape
on straight. This step will determine how well
your quilts load in the future. Use the Spring
Coupler Snap Buttons as a guide when aligning
the hook & loop tape for best results.
16-1: Prepare to attach the Velcro to the quilt
top pole, backing pole, and take-up pole, by
measuring in 3" from each end of the pole. Peel
the backing off the hook & loop tape as you go
and apply to all three poles, starting at the 3"
mark and ending at the opposite 3" mark. Take
care to stick the hook & loop tape on straight.
This step will determine how well your quilts
load in the future. Use the spring buttons as a
guide when aligning the hook & loop tape for
best results. Hint: Attach the hook & loop tape
next to the snap buttons, not between.
Once the hook & loop tape has been adhered
from one end of the poles to the other, it can
be clipped where the poles meet at the pole
coupler.
Fig. 15-1
27
Hide quick links:
Advertisement
Table of Contents
