Baby Lock Pearl BLQF Assembly Instructions Manual page 22

Step 11
Pole End Assembly
Step 11: Pole End Assembly
Parts needed
4-Pole Assembly
5-Pole End
2-Short-Bolt Ratchet Wheel Assembly
1-Long-Bolt Ratchet Wheel Assembly
1-Hand Wheel Assembly
1-Hand Wheel Insert
Tools Required
17/13mm Wrench (Provided)
11-1: Check one pole end to ensure that it
matches Fig 11-1 and 11-3.
11-2: Loosen the nut on the pole end until it
reaches the end of the bolt (Fig. 11-2).
11-3: Holding onto the outside pole end, push
the nut end of the bolt towards the opposite
end of the assembly (Fig. 11-1), until the pole
end short-bolt wedge slides out (Fig. 11-2).
This makes the outside diameter of the pole
end smaller and ready to be inserted into the
end of the pole assembly.
11-4: Repeat Steps 11-1 to 11-3 to prepare the
remaining four (4) pole ends for insertion.
NOTE: A regular M10 nut is provided as an
assembly aid tool if you have trouble holding
the pole end while tightening the pole end into
the pole.
11-5: Slide one pole end into the end of one
pole assembly as shown in Fig. 11-4. Check
that the pole end is inserted completely into the
pole assembly.
11-6: Completely tighten the nut, using the
17/13mm wrench, while holding the pole end
assembly tightly into the open end of the pole.
This will expand the outer pole end, ensuring a
tight fit into the pole.
22
Push
Fig. 8-1
Fig. 9-1
Fig. 9-1
Inside Pole End Short Bolt Wedge
Pole End
Pole End assembly comes pre-assembled. Exploded diagram is
for reference only.
Loosen Nut
Wedge
Fig. 11-1
Outside Pole End
Large Washer
V Bearing
Fig. 11-2
Fig. 9-2
Fig. 9
Small Washer
Lock Nut
Fig. 11-3
Fig. 11-4