Step 6: Mounting Clamp To Frame Assembly - Baby Lock BL J18-QM Installation Manual

Step 6: Mounting Clamp to Frame Assembly

Parts Needed:
1- Belt Clamp Assembly
1- Belt Tensioner Housing Assembly
2- M6x40mm Hex Bolts
2- 18mm Plastic Spacer
Long Screw
Belt Tensioner
Clamp
Fig. 6-C
Fig. 6-D
Fig. 6-E
Pg. 12
Fig. 6-A
6-1 . Using a wrench, unscrew the take-up rail end
from frame. Then unscrew the black plastic knob
and remove the screw behind the knob as shown
in Fig. 6-A and 6-B.
6-2. Replace the screw you just removed with
a M6x40mm Hex Bolt. Slide one end of the Belt
Tensioner Clamp (assembled in step 3) over the
M6x40mm Hex Bolt and clip the other end to the
frame, as shown in Fig. 6-C.
6-3 . Place a 18mm Plastic Spacer over the Hex
Bolt as shown in Fig. 6-D.
6-4 . Screw the black plastic knob back into place
to secure the rail end and Belt Tensioner Clamp as
shown in Fig. 6-E.
6-5 . Repeat this process for the Belt Clamp with
the belt on the other side of the frame, as shown
in Fig. 6-F. Make sure that the belt teeth are facing
down.
Belt Clamp
Fig. 6-F
Fig. 6-B