Step 1- Remove Track Supports - Baby Lock Pearl BLQF Assembly Instructions Manual

Step 1
Remove Track Supports
Step 1: Remove Track Supports
Parts needed
2-Table Section
Tools Required
4mm Allen Wrench (Provided)
NOTE: The track support finish could be
damaged if not protected or if placed onto a
rough surface. Handle with care.
1-1: Place the table sections with the track
supports face down onto a protective surface.
(Fig. 1-1)
NOTE: When removing the track supports,
keep them in the same position and orientation
to ensure perfect alignment when they are
replaced.
6
1-2: Using the 4mm Allen wrench remove the
three screws from each track support and set
the track support aside in a safe place
(Fig. 1-2). Leave the table sections face down
for Step 2-1.
Fig. 1-1
Fig. 1-2