Passive Arming With Passive Door Locking; Passive Arming By-Pass; Active Disarming - Unlock & Disarm; Tamper Disarming - Autopage RS-720LCD Operation Manual

PASSIVE ARMING WITH PASSIVE DOOR LOCKING

The vehicle doors will automatically lock after the passive arming cycle has been
completed.
PASSIVE ARMING BY-PASS: While the system is disarmed, Press the
twice, the system will respond with [1] chirp and LED will turn "ON". The security
system will remain in this temporary state for as long as you wish. To exit passive
by-pass, press the transmitter
normal status.
I. ACTIVE DISARMING – UNLOCK & DISARM:
1. Press button on the transmitter.
2. The siren will chirp twice and the parking lights will flash twice indicating that
the security system is now disarmed. The vehicle's doors will unlock and the
dome light will turn on for 30 seconds upon disarming. (Note: Power door locks
and dome light must be installed with the security system.)
System Disarm Doors Trigger
Shock Sensor Trgr Ignition Trigger
TAMPER DISARMING : If the alarm is triggered upon disarm, the system's siren will
chirp 4 times, and the parking lights will flash 3 times.
PATHWAY ILLUMINATION: When receiving an unlock /disarm signal, this feature will
turn the parking lights "ON" for 30 seconds and for 10 seconds upon the lock signal.
TWO STEPS DOOR UNLOCK: This feature will independently unlock the driver's door
only when disarming the security system. Pushing the
within 3 seconds will unlock the other doors.
AUTOMATIC RE-ARM : If this feature is selected, the security system will
automatically re-arm itself in 60 seconds after disarming with remote transmitter.
Automatic rearm will cancel if any door is opened before the 60 seconds timer has
elapsed.
J. DISARMING WITHOUT A TRANSMITTER

OVERRIDES THE ALARM WITHOUT PASSWORD PIN CODE:

(Factory Default Setting)
The Override function may be used if the remote transmitter is lost or inoperative.
1. Enter the vehicle and turn the ignition switch to 'ON' position.
or buttons and the system will return to
Trunk/Hood Trigger
Clear The Flash Icon:
Press the button 3 times within 3
seconds to clear the flash icon on the LCD
screen transmitter.
button a second time
8
button