Ignition Control Door Locks; To Remote Start The Vehicle - Autopage RS-600 Operation Manual

2. Push and hold valet switch for 2 seconds until the LED turns on.
The LED will remain on as long as the system is in 'valet mode'.
Exit Valet Mode:
1. Return to normal operation, turn ignition 'on'.
2. Push and hold valet switch for 2 seconds, The LED will turn off
indicating the system has exited the valet mode.

IGNITION CONTROL DOOR LOCKS.

If the vehicle's door locks have been interfaced to the security system,
the system will automatically lock the vehicle's doors when the ignition
is turned "ON" and /or unlock the vehicle's doors when the ignition is
turned "OFF".
TRUNK RELEASE (Additional Installation Required)
Press and hold the
control the trunk release or other electric devices.
WARNINGS:
As with any product that performs automatic functions, there are certain
safety precautions that you must practice and be aware of.
1. Keep the transmitter out of children's reach.
2. Do not leave anyone in the vehicle while running on remote control.
3. Alert servicing personnel that the vehicle can be started automatically.
4. Do not start the vehicle by remote while it's in an enclosed area or
garage.
5. Always apply the parking brake and lock the vehicle as you exit the
vehicle.
6. Should the unit malfunction, disconnect the fuse until the problem is
corrected.
7. The use and operations of this system is the sole responsibility of the
operator.
8. Some areas may have local ordinances that prohibit leaving a vehicle
running on public streets.
A. TO REMOTE START THE VEHICLE:
When you want to start your vehicle,
1. Press button TWICE on either remote transmitter.
2. The parking lights will flash to indicate the remote start received the
signal.
3. The engine will start in approximately 5 seconds.
4. Once the engine is running, after a couple of seconds the parking
button on transmitter for two seconds to remote
REMOTE START OPERATION:
5